Suzuki 2010 VZ800L0, Дополнительное руководство по обслуживанию

Страница: 24 / 42

VZ800L0 (’10-MODEL) 23
WIRING HARNESS ROUTING
*1 Cut off the excess end of the clamp. *8 Push the coupler inside of the frame.
*2
Pass the starter motor lead wire inside of the
coupler.
*9
Do not contact the plug caps with cylinder head
cover cap.
*3
Pass the speed sensor lead wire, left and right
handlebar switch lead wires in front of the main
wiring harness.
*10
Do not pinch the left handlebar switch lead wire
and IG switch lead wire with cable, wiring har-
ness and IG switch.
*4
Connect the gear position switch inside of the
cover.
*11
Pass the front turn signal coupler behind of the
handle switch coupler.
*5 Do not make slacked part. *12 Pass the lead wire behind of the bracket.
*6 Do not pass the high tension cable over the bracket. *13 No clearance.
*7
Do not pinch the wiring harness with PAIR pipe
and water hose.
*14
Do not pinch the lead wires between the cover
and fender boss when assembling the cover.
Clamp
Wirring harness
Handlebar switch (L & R)
Clamp
Wiring harness
Speed sensor
Handlebar switch (L & R)
Frame
High tension
cord (Rear center)
High tension
cord (Rear side)
High tension cord
Clamp
Wiring harness
Solenoid branch wire
High tension cord
Clamp
To horn
*7
Clamp
*2
Starter motor
lead wire
Clamp
To
generator
*6
Reservoir
inlet hose
Clamp
Wiring harness
Generator lead wire
Clamp
*5
Clamp
Taping
*4
*1
*8
*9
*10
Clamp
Wiring harness
Speed sensor
Handlebar switch (R)
Clamp
Handlebar switch (L)
Clamp
*11
*12
*14
*1
*1
*1
100 ± 10 mm (4.0 ± 0.4 in)
70 ± 10 mm (2.8 ± 0.4 in)
150 ± 10 mm
(5.9 ± 0.4 in)
80 ± 10 mm
(3.5 ± 0.4 in)
70 ± 10 mm (2.8 ± 0.4 in)
*13
*3
Clamp
*11
Speed sensor coupler
VIEW A
A