Manual Round video topper
version 1.7
Page 3
6. Synchronize toppers
You may synchronize color and flashing pattern for round video toppers connected in series as below:
Connect round video toppers with synchronize cable (J1 and J7) together. Conduct settings to change
color and /or flashing pattern through any one of the toppers connected in series. If Toppers are
connected in series, the first powered up topper will dominate the color and pattern for whole series
until it is changed.
7. Operation
7.1. RGB flashing patterns
There are 2 buttons on the rear of the round video topper, for the setting of the RGB leds
Color button:
You may select flashing color set out of seven pre-defined combinations as below:
Press
“COLOR” button on the main control board once - Topper will switch to next and stay on this
color set until COLOUR button is activated again. Last color setting will be stored to memory when
power off.
The seven color sets are defined as follow:
1. Red - Blue - White (Default setting)
2. Green - White - Red
3. White - Yellow - Red
4. Yellow - White - Blue
5. Blue - Purple - White
6. Green - Blue - Yellow
7. Green - Red
– Blue
Mode button:
You may select flashing patterns as below:
Cycling through 13 pre-programmed flashing patterns (Default setting)
Press MODE button once - Topper will switch to next flashing pattern and stay on
this pattern until MODE button is activated again. Press and hold MODE button for 3 seconds - Topper
will resume to default setting and cycle through the pre-programmed patterns. Last flashing mode will
be stored to memory when power off.
MODE COLOR
