Suunto Observer, Инструкция по эксплуатации

Страница: 22 / 42

20
NOTE:
An activated altitude alarm is indicated with an alarm symbol.
7. At the desired setting, press the [SELECT] button to move to the next setting. In the
middle field, the alarm altitude will begin to flash.
8. Press either the [ON OFF] button to scroll the value up or the [QUICK] button to scroll
down.
9. At the desired altitude, press the [SELECT] button to view the setup preferences for
confirmation or for additional changes, or press the [MODE] button to accept the changes
and exit.
NOTE: You can return to main ALTI display by pressing [MODE] during any of the steps 1-9.
Once you have set the reference altitude of the current location to the known altitude, the
Observer will also correct the sea level pressure, and therefore, it will not be necessary for
this function to be set.
NOTE:
Setup mode will automatically be released if left idle for more than one minute.
3.3 LOGBOOK SUB MODE
3.3.1 Starting and Stopping a Logbook Recording
In the main altimeter mode, a logbook recording starts by performing two short presses of
the [ON OFF] button. An ongoing recording is indicated with flashing “LOG” text in the bottom
field. To stop a logbook recording, you must be in the altimeter mode and perform two short
presses of the [ON OFF] button again.
The memory capacity is 99 logs, each at maximum 20 hour duration. After recording the 99
th
logbook, the Observer writes the next logbook over the logbook number 1 (the oldest log)
and then continues in numeric order.
The logbook is recording in 10-second intervals, which is quick enough for all activities. It is
not possible to view the individual values of the logbook.
NOTE: You can be in other modes while recording. To indicate logbook-recording activity, the