Installation:
•
Use the included template to mark and cut the mounting hole in the
drywall. Be sure the hole location allows the speaker to clear the
wall stud.
•
We recommend wiring with AWG 16 or larger, stranded wire.
•
Find the speaker wire leads and pull them through the hole and carefully
connect the leads to the speaker terminal block. Pry up the red (+) and
black (-) levers and insert the wire. Then snap the levers into the ‘down’
or closed position, making sure to capture the wire securely. Be sure to
observe proper polarity when connecting the speaker wire to the
terminal bock and make sure both speakers are connected the same
way. To simplify installation the speaker connector may be detached
from the speaker for insertion of the wire, then plugged back into the
header after the wire is captured.
•
Install the SAS-6W in hole. Tighten the mounting screws clockwise.
The clamps will rotate outward and begin to grip the drywall. Tighten
until snug.
•
The speaker system is now ready to be turned on.
Features:
•
1” Ultra-wide dispersion dome tweeter
•
Polypropylene
cone
•
1” aluminum voice coil easily copes with the heat and power of
extended use
•
Two-piece speaker connector simplifies installation and provides a
better connection
