Sutter Instrument Lambda 421, Руководство по эксплуатации

Страница: 6 / 42

LAMBDA 421 OPERATION MANUAL – REV. 1.00N (20170623)
iv
ƒ
Operate only in a location where there is a free flow of fresh air on all sides.
NEVER ALLOW THE FREE FLOW OF AIR TO BE RESTRICTED.
ƒ
This instrument is designed for operation in a laboratory environment (Pollution Degree
I) that is free from mechanical vibrations, electrical noise and transients.
„
DO NOT CONNECT OR DISCONNECT THE LQUID LIGHT GUIDE BETWEEN
THE LAMBDA 421 AND MICROSCOPE ADAPTER (OR THE ADAPTER FROM THE
MICROSCOPE) WHILE POWER IS ON.
„
Operate this instrument only according to the instructions included in this manual.
„
Do not operate if there is any obvious damage to any part of the instrument.
„
Do not operate this instrument near flammable materials. The use of any hazardous
materials with this instrument is not recommended and, if undertaken, is done so at the
users’ own risk.
„
Do not operate if there is any obvious damage to any part of the instrument.
Avoiding Physical Injury while Powered up and Emitting Light
ƒ
INFRARED AND ULTRAVIOLET RADIATION: Possible infrared and ultraviolet
radiation generated by this lamp can cause significant skin burns and eye damage.
Other
ƒ
Retain the original packaging for future transport of the instrument.
ƒ
Sutter Instrument reserves the right to change specifications without prior notice.
ƒ
This device is intended only for research purposes.
WARNING
DO NOT LOOK DIRECTLY INTO THE OUTPUT OF THE LIGHT
APERTURE OF THE OPTICAL BEAM COMBINER MOUNTED
ON THE CONTROLLER, THE CONNECTED LIQUID LIGHT
GUIDE, OR THE ATTACHED MICROSCOPE ADAPTER! Always
direct the output of the light aperture into the microscope using the
appropriate adapters, directed away from anyone’s eyes, and not
directed toward any reflective surface.