Service and maintenance
FixFrame – Assembly Instructions
Page 34
Remove all cleaning aids after performing cleaning work.
Retract the table base frame before cleaning.
Remove the load from all lifting elements before maintenance works.
Unplug the motor control from the mains before cleaning.
Clean the system components with a mild detergent and a damp cloth.
Liquid entry of any kind must be strictly avoided.
Do not use any corrosive detergents or high pressure washing systems to clean the
components of the table base frame.
Grease may be carried over during operation, leading to so-called run marks on
visible pipe surfaces. These may be wiped off with mild cleaning agent and a cloth.
Before restarting operation make sure the system is clean and dry.
6.3
Maintenance
The table base frame should be inspected on a regular basis. In case components are worn or
damaged excessively, they must be replaced without delay.
6.3.1
Overloading the table frame
Overloading the table frame must be avoided in any case.
IMPORTANT
Drives that repeatedly turn off automatically are an indication that the system is
overloaded.
6.3.2
Damages to electrical wires
Check the insulation of the electrical wires for visible signs of aging and wear. Replace defective or
damaged wiring.
