Surveon CAM6471LZ, Руководство пользователя, Страница: 52 / 116

51
Triggered Action (Multi-option)
The administrator can specify alarm actions that will take at an alarm
occurrence. All options are listed as follows.

Enable Alarm Output 1/2
Select these items to enable alarm relay outputs.

Send Message by FTP/E-Mail
The administrator can select whether to send an alarm message by FTP
and/or E-mail when an alarm is triggered.

Upload Image by FTP
Select this item and the administrator can assign an FTP site and
configure various parameters. When the alarm is triggered, event
images will be uploaded to the appointed FTP site.
<Pre-trigger buffer> function allows users to check what caused the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after the alarm input is triggered.
NOTE: Normally the setting range of the <Pre-trigger buffer> is 1
frame to 20 frames. However, the setting range will change
accordingly if the frame rate of MJPEG on the <Video Frame
Rate> setting page is 6 or smaller.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off.
Select <Upload for sec> and enter the duration in the blank.
The images of the duration will be uploaded to FTP when the alarm input
is triggered. The setting range is from 1 sec. to 99999 sec. Select
<Upload while the trigger is active> to make the images keep being
uploaded to FTP during the trigger active until the alarm is released. Set
the Image frequency as the upload frame rate. The setting range is from
1 frame to 15 frames per second.
NOTE: Make sure the FTP configuration has been completed.
Refer to section FTP for further details.