Hydraulic Oil fill
tube & dipstick
Hydraulic Valve
Control
Before Starting
Before beginning operation of your woodsplitter be sure to read
and understand operating and safety instructions as outlined in the
woodsplitter and engine operator’s manuals.
Starting Operation
For engine starting instructions, see applicable engine operator’s
manual. Before operating the woodsplitter check hydraulic oil level and
check to make sure wedge slide is free from all obstructions and debris.
Never run woodsplitter inside without adequate ventilation as it will
cause carbon monoxide poisoning. Never permit a minor or incompetent
operator to operate machine.
Woodsplitter Operation
When machine is in desired location, set adjustable back leg (2) to
stabilize machine. To operate in horizontal position, simply start engine
and machine is ready to work.
The wedge will move the same
direction as the valve lever (1) is pushed
. To split a log, push forward
on the lever to extend cylinder and wedge. When log is split, pull lever
back until you feel it lock into the valve detent and it will return and stop
automatically. Woodsplitter can also be used in the vertical position
by releasing spring latch and lifting it to upright position. Always keep
sliding wedge mechanism free of all foreign material.
(A)
Maintenance
Always keep the oil reservoir filled within the flat area on the dipstick
(A). Your woodsplitter comes shipped from the factory with Dexron III
transmission fluid installed because it easily handles a wide range of
temperatures. Change oil if it becomes discoloured or every 500 hours
of use. The oil filter should be changed at least every 500 hours of
operation. Oil capacity of the reservoir is approximately 13 litres. Keep
wheel bearings well greased.
