9
This will give you a listing of all the CD-ROM’s and DVD’s attached to the system, including the SurfSTOR DVD-
RW. If you have more than one SurfSTOR DVD-RW, then be careful to note the NEW SurfSTOR DVD-RW that
has been added. If you do not know which one that is and have multiple units listed, it is recommended that you put
a CD or DVD with information on it already into the SurfSTOR and type: “
ls”
for each cdrom
X
(where
X
is the
cdrom number assignment) until you see the contents of the disk. Make note of the cdrom# as it will list them as
cdrom0, cdrom1, and so on.
3.
Now determine if your SurfSTOR DVD-RW device mapped to the system correctly by running the iostat -En
command:
mycomputer#
iostat -En
c0t6d0
Soft Errors: 1 Hard Errors: 0 Transport Errors: 0
Vendor: PLEXTOR Product:
DVDR PX-800A
Revision: 1.0 Serial No:
Size: 0.00GB <0 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 1 Predictive Failure Analysis: 0
STEP 8: Manually Mounting the DVD-RW
The Volume Manager needs to be turned off any time you write to a CD or DVD (This will be discussed further
in the SurfBURNER portion of the manual). Once it has been turned off however, the DVD-RW and any other
ROM type unit will not be automatically mounted and will need to be mounted manually. To mount the SurfSTOR
DVD-RW with volmgt stopped, you must do the following:
1.
To mount the DVD-RW drive to a directory, put a written CD or DVD in the drive and mount it by typing the
following:
#
mount -o ro -F hsfs /dev/dsk/c
#
t
#
d
#
s0 /some_directory
(
Note:
Put the desired mount point directory in place of
/some_directory - i.e. /cdrom
)
The actual SurfSTOR device varies based on where it is plugged in on the SCSI chain. You can find this
information from the output of the probe command done in STEP 7 or by typing: iostat -En and looking for the
c#t#d# number.
mycomputer#
iostat -En
c0t6d0
Soft Errors: 1 Hard Errors: 0 Transport Errors: 0
Vendor: PLEXTOR Product:
DVDR PX-800A
Revision: 1.08 Serial No:
Size: 0.00GB <0 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 1 Predictive Failure Analysis: 0
3.
At this point, you should have your # prompt back and the drive mounted to the desired directory. To confirm this
you can use the ‘df’ command with a -k option. The ‘df -k’ command will report free disk space in kilobytes on a
mounted partition. This will confirm that the disk drive is mounted.
mycomputer#
df -k
Filesystem kbytes used avail capacity Mounted on
/dev/dsk/c0t6d0s0 503084 503084 0 100% /cdrom
Note: If you don’t see the drive, then repeat step 9.
Содержание SurfBurner
Страница 1: ......
