5
OPERATING INSTRUCTIONS
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Connections leak.
1. Loose connections.
1. Retighten fittings.
2. Sealant worn.
2. Reapply pipe tape.
3. O-ring is worn.
3. Replace O-ring.
Unit won’t spray.
1. Unit power / water supply off. 1. Consult owner's manual.
Grey knobs won’t trun.
1. Overtightened.
1. Spray lubricant on threads on
inside of grey knobs.
2. Unit is clogged.
2. Reverse flush unit with water.
CARE AND MAINTENANCE
The 9 ft. PW extension wand will flex as pressure is added or lost. Fully understand how the wand
moves when adding or releasing pressure before attempting a cleaning project. If you are not
completely comfortable with the movement of the wand under changing pressure conditions, do not
use this product.
WARNING:
Extend the wand only as much as necessary for the project you are attempting and remain in full
control of the 9 ft. PW extension wand at all times.
WARNING:
To reduce the risk of injury or property damage, test the 9-ft PW extension wand in a safe direction
to ensure proper connection of all accessories before starting any cleaning project. Fits most
pressure washers. Ensure compatibility and proper fit before using this accessory. Wear eye
protection marked to comply with ANSI Z87.1. Risk of fluid injections; do not point at people, pets,
electrical devices or the unit itself. Turn off the pressure washer before changing or adjusting
accessories. For cold water use only. Save these instructions. Refer to them frequently and use
them to instruct other users. If you loan someone this tool, loan them these instructions also.
WARNING:
Adjust the 9 ft. PW extension wand as needed to fit your project requirements.
Move to the project area, raise the wand and aim toward the area to be cleaned. Squeeze the
trigger to begin spraying.
To engage the trigger lock, push up on the lock-out until it clicks into the slot. See figure 5.
To disengage the trigger lock, push the lock-out down to its original position.
5
Trigger lock
www.surfacemaxx.com
• If a cleaning solution was run through the wand, run just water through the wand before shutting
off.
• De-pressurize by squeezing the gun trigger until all of the water has been drained out of the unit.
