SURF & TURF Amalfi Parasol, Инструкция по эксплуатации

Страница: 9 / 22

Lift rotation handle
Figure A
Rotate the parasol by using the handle
Figure B
Align the indicator arrow with a notch
Figure C
There are 16 pre-determined location holes
in the spigot. These location holes are
found at every 22.5 degrees interval around
the spigot base. They are located where
indicated on the spigot base and are under
the nylon indexing shield (34) which acts as
a dust cover for the holes not in use.
1. Pull the rotation lift handle (35) out from
the mast cavity
(refer Figure A)
2. Lift up on the handle and feel the
resistance from the spring that houses
the rotating lock pin (36).
WARNING: In lifting this handle you are
not attempting to lift the whole parasol,
rather just the spring on the rotating lock
pin that locates the rotation lock pin.
Do not apply too much force when
lifting up on the handle.
3. By using the rotating lift handle (35) as a
lever you may rotate the parasol on the
base
(refer Figure B) until you arrive at
the new required position.
NOTE: There is some resistance to
rotation as the weight of the parasol
when opened and friction need to be
overcome. For easier rotation close
the parasol canopy first.
4. Each position is marked by a notch on the
spigot base. Align the indicator arrow
with a notch
(refer Figure C). Once
aligned with a notch, lower the rotating handle
down to locate the rotating lock pin.
WARNING: Do not force the rotating handle down
if the indicator arrow is between notch positions.
The rotating handle should close down easily.
If any resistance is encountered do not force it,
rotate the parasol further slightly to locate the correct hole position.
TO ROTATE PARASOL