Surewerx JET JDP Series, Руководство пользователя

Страница: 9 / 18

9
Installing Chuck
Unplug machine from power source
Note: Make sure the arbor nose is clean of any
oil or rust protectant before mounting chuck. On
models equipped with a Morse taper make sure all
rust protectant is cleaned off before inserting arbor.
You can inspect this by lowering the quill, using the
down feed handles, and rotating the spindle until
the knock out hole in the spindle lines up with the
knock out hole in the quill.
1. Slide small end of arbor (71) into chuck (72A).
2. Place long end of arbor (71) into spindle (58).
Rotate arbor to line up tang with spindle.
3. Raise table (21) to within 5 inches of chuck.
Place a block of wood on table and lower
chuck assembly to block of wood with handle
bar assembly (43A).
4. Press firmly to set assembly in spindle.
IMPORTANT: Spindle, arbor, and drill chuck have
to be clean of protective grease. Chuck and spindle
may not seat properly if these parts are not clean.
Removing Chuck and Arbor
Unplug machine from power source
1. Lower quill using handle bar assembly.
2. Align key hole in quill with key hole in spindle
by rotating spindle.
3. Insert wedge directly in aligned key holes and
tap lightly (place hand under chuck to catch
assembly before it hits table).
58
72A
71