3
!
SETUP
operation
!
MAINTENANCE
1. When not in use, store the jack in a dry locati on with saddle in lowest positi on.
2. Periodically check the piston rod for signs of rust or corrosion. Clean exposed areas with a clean oiled cloth.
Warning: Never use sandpaper or abrasive material on these surfaces!
3. A coati ng of light lubricati ng oil to pivot points, axles and hinges will help to prevent rust and assure that castors, foot pedal and pump
assemblies move freely. Periodically lubricate the pivot points, axles and hinges with a light lubricati ng oil as needed.
4. With jack in its lowest positi on, remove the air vent screw (25) to check the hydraulic oil level. If it is not adequate, add high quality
hydraulic jack oil as necessary. Insert and ti ghten the air vent screw. Then purge away air from hydraulic system as described in purging.
Warning: DO NOT use brake fl uid or any other improper fl uid and avoid mixing diff erent types of oil when adding hydraulic oil.
5. To ensure best performance and longer equipment life, replace the complete hydraulic oil at least once a year. With jack in its lowest
positi on, remove the air vent screw (25), lay the jack on its side and drain the oil into a suitable container. Ensure that no dirt gets into
the system. Set the jack in its level upright positi on, fi ll with approved hydraulic jack oil. Then replace the air vent screw (25) and purge
away air from hydraulic system as described in purging air.
Note: Dispose of hydraulic oil in accordance with local regulati ons.
6. When equipment effi ciency drops, purge away air from hydraulic system.
7. It is recommended that an annual inspecti on be done by qualifi ed technicians.
WARNING!
Ensure that you read, understand and apply the safety instructi ons and warnings before use. Failure to heed these instructi ons may result in property
damage and/or personal injury.
1. Roll the transmission jack into positi on and pump the foot pedal (35) unti l saddle reaches desired height.
NOTE: Follow vehicle manufacturer’s recommended procedures for removing the load as outlined in vehicle service manual or repair guide.
2. Carefully center load on the saddle. Ensure the load's center of gravity is centered on the saddle and the setup is stable and secure.
NOTE: Before lowering load check to ensure all tools and personnel are clear and it is safe to lower the load.
3. SLOWLY and CAREFULLY operate the release pedal 32 to lower the load to its lowest possible positi on.
4. If necessary, CAREFULLY and SLOWLY move the jack.
5. Transfer load immediately to appropriate support device for service or repair.
Содержание 030538
Страница 6: ...6 PARTS...
