9
STARTING UP YOUR INCUBATOR:
STEP 1: Plug in your incubator:
Switch
ON
your incubator by
plugging it in to the wall plug
.
STEP 2: Fill the water container/pan with clean water and place below the
hatching crate (You may remove the hatching crate when not in use)
Make sure that you check the container daily and fill with CLEAN WATER as
required.
STEP 3: SETTING INCUBATOR TEMPERATURE: (This will take about 1 hour)
The incubator has been factory set to heat up to 99.5°F
(37.5 Degrees Celsius) when you
switch it on. The incubator will take about 1 hour to heat up to 99.5°F
***You can change the temperature display from Fahrenheit to Celsius by
pressing both TEMP UP and TEMP DOWN together at the same time and keeping
it pressed for 6 seconds
.
Next steps:
- Close incubator door
- Wait for incubator to reach 99.5°F
- To change the incubator temperature set-
point simply press the “Temp Up” or “Temp Down” Button
(Generally not required
– only for advanced users)
