Ensure that the mounting area has at least a 12-inch radius clear of obstructions and other radiating elements and orient
the antenna with the drip hole at the bottom.
Once you have identified your install location, assemble the u-bolt, bracket, nuts and washers onto a pole or pipe (not
provided) as shown in the illustration. Keep the connections loose enough to allow the antenna to rotate until the optimum
direction is found.
Once the outside antenna is secured to a pipe or pole, connect antenna to one end of the provided RG6 cable and tighten
the connection. Run the cable along route to planned location of your booster.
Note: Avoid placing either component (booster or outside antenna) near windows where possible as it increases the poten-
tial for oscillation.
Installation
Cable
Planned
Booster
Location
Outside
Antenna
minim
um 25
ft. se
parati
on
Yagi Antenna Install Illustration
Note: This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury,
and void your warranty.
This booster should not be used near open fire or flame. Storage and transportation: Store and place in non-extreme room-temperature and dry environment.
Nut
Washer
U-bolt
Bracket
Drip Hole
RG6 Cable
Outside Antenna Assembly
8
https://www.signalbooster.com | 855.846.2654 | [email protected]
