7
2. Using supplied plate, mark position of desired placement with a pencil or
marker.
3. Screw (not supplied) mounting plate into place with the slide panel
protruding towards you. Provided plastic anchors are only to be used
for sheetrock installation.
4. Slide antenna securely onto mounting plate.
5. Use the additional 20-ft CM240-M cable to connect the antenna to the booster
connector labeled (INSIDE).
Note: Be sure to provide enough separation from outside antenna (see table on
page 6. Panel antenna should not face the outside antenna.
Option 2 : Low Profile Usage
1. The supplied 248W-M patch antenna is intended for indoor use only. Do not
mount on a surface within 4” of metal.
2. Screw the patch antenna cable to the booster connector labeled (INSIDE).
Note: Laboratory tests show that patch antennas can work from as close as 2 feet
from outside antennas if the patch antenna is facing away from the outside antenna.
If the booster shows oscillation (red light blinking), turn it down in 3 dB increments on
the dial of oscillating band until the light stops blinking.
