Step 4. Connect Power and Verify Successful Operation
Step 2. Install the Signal Booster and connect Inside Antenna
www.SureCall.com | 1-888-365-6283 | [email protected]
6
Step 2. Install the Signal Booster and connect Inside Antenna
Connect the inside whip antenna to the port on the side of the booster labeled “INSIDE”.
Identify a location for the booster that is near the center of where signal is needed.
The location should be free from excessive heat, direct sunlight, or moisture, as
well as provide proper ventilation.
Mount the booster within a cabinet or on a side panel close to a power source.
Connect the inside whip antenna
to the port on the side of the
booster labeled “INSIDE”.
Note that the inside antenna
sends signals in a 360 degree
radius and should be positioned
vertically.
Step 3. Connect Outside Antenna Cable to the Signal Booster
It is advisable to first perform a “soft” installation by routing the outside antenna cable through an
open window. After completing the “soft” installation and verifying successful operation, proceed with
permanent cable installation below.
NOTE: If you choose to drill a hole for cable entry, do so on the side of the vehicle, away from other
cables or pipes. Use a rubber gasket (sold separately) to protect the cable and your vehicle surface.
Form a drip loop before entry and create a moisture barrier using a permanent sealant. Finish your
permanent cable install by securing any loose cables inside the vehicle.
Route the cable from the outside antenna to the port on the booster labeled “OUTSIDE”. Make sure
that all connections are secure before powering on.
Cable
LTE-A
LTE-V
CELLULAR
PCS
AWS
POWER
Fusion2Go 3.0
Omni Antenna
LTE-A
LTE-V
CELLULAR
PCS
AWS
POWER
LTE-A
LTE-V
CELLULAR
PCS
AWS
POWER
Anchors /
Sleeves
Screws
