pinch and push in
tie the wires
Adjustment of torque force
after installation
Adjust torque force
WARNING
WARNING
Decrease
Increase
360° rotation is not suggested if gravity of
monitor is not in the center of it.
360° rotation
C2
D1
D2
open the ties
tighten the screw
C1
pinch and pull out
unscrew the
pre-positioned
screw
C3
S4 wrench
S4 wrench
C: Cable management
E: Adjustment of joints
D: Adjustment of torque force
+: Increase torque force
- : Decrease torque force
WARNING:
Do not loosen the
screw completely.
1. The monitor could stop at any height after hung on the
mount. No adjustment needed.
2. The monitor bounces itself after hung on the mount. Press
down the monitor with one hand and make sure the arm is
horizontal. Use S5 wrench and turn the screw in “-”
direction with the other hand (little by little) until the monitor
can stop at any height.
3. The monitor falls itself after hung on the mount. Raise the
monitor with one hand and make sure the arm is horizontal.
Use S5 wrench and turn the screw in “+” direction with the
other hand (little by little) until the monitor can stop at any
height.
±180° swivel
±80°
1. Make sure the monitor is hung on the mount before adjustment.
2. Make sure the weight of monitor is within the capacity.
after-sales@suptekmount.com
S5 wrench