Before the Hair Cut
1.Inspect the clipper, making sure that it is free of oil between the cutting blade
teeth and turn the unit on to distribute the oil and to make sure it is running
smoothly. Wipe off any excess oil.
2.Before cutting always first comb the hair so it is tangle free and as it is
naturally worn.
Attachment Guide Combs
Cutting hair requires practice so It is always better to leave the hair longer for
the first few haircuts until you become used to the length to which each comb
attachment cuts the hair.
Step 2-Back of The Head
• Change to the next longest comb attachment 9mm or 12mm and cut the back of the
head.(See diagram 2)
Step 3-Side of The Head
• Change to one of the shorter combs 3mm or 6mm, trim sideburns, i.e. the hair directly
in front of the ears. Change to one of the longercombs, 9mm or 12mm, and continue to
cut to the top of the head.
(See diagram 3)
Step 1-Nape of The Neck
• Attach comb attachment 3mm or 6mm.
• Hold the clipper cutting edge pointed up and begin the haircut, starting at the centre
of the head at the base of the neck .
(See diagram 1)
• Hold the clipper comfortably in your hand and hold lightly against the head with the
comb teeth pointing upward. Gradually and slowly lift the clipper working upwards and
outwards, through the hair, trimming just a little at a time.
• As you cut, gradually lift the clipper head towards you. Continue to cut the back area
from the bottom of the neck upwards to the top of the ears.
1. Guide combs should be installed by first hooking the blade teeth front side of
guide comb. Then press the back of the guide comb down until it snaps into
place.
(See picture on the right)
2. Ensure comb is attached before beginning to cut hair.
3. To remove, pull the snap tab on back side of guide comb and pull the comb off.
Notes: The first time you cut hair, cut only a small amount of hair until you become accustomed
to the length of hair each guide comb provides-Start by attaching the largest guide comb on the
clipper.
-Then use shorter guide combs if a shorter length is desired.
-For uniform cutting, cut at a slow, even speed.
BASIC PARAMETERS
STEPS FOR HAIR CUTTING
STEPS FOR HAIR CUTTING
Motor
：
Voltage
：
3.2V
Speed
：
7000RPM
Decibel:
≤
65dB
Charging Interface: Type-C
Battery: Type: Lithium Battery
Power Supply Input: DC 5V 1A
Battery Capacity: 1400mAh
Charging Time: 2H
Running Time: 3H
Содержание HC315
Страница 5: ...HAIR CLIPPER HC315...
