Installation
12
Connecting to an Automatic door
How to configure a Relay
Set up the relay according to the following steps only when BioStar is not used to set up the door.
1
Press the
MENU
button, and then authenticate with the administrator authentication method.
2
Select
Device
>
Door
>
Relay
, and then press the
OK
button.
3
Press the
OK
button after entering the time that the relay is on.
4
Press the
OK
button after entering the time that you want.
5
Select
Door Sensor
, and then press the
OK
button.
6
Press the
OK
button after selecting the port that will be used to control the door sensor.
7
Select
Exit Button
, and then press the
OK
button.
8
Press the
OK
button after selecting the port that will be used to control the exit button.
•
The
INIT
switch of Secure I/O 2 should be pressed after completing the relay setup when Secure I/O 2 is used together.
•
Refer to BioStar administrator guide when setting up the door with BioStar.
Note
BioLite Net
13 - RLY COM
Green (White stripe)
14 - RLY NO
Gray (White stripe)
Sensor
Automatic door
controller
Door button
Door lock
14
13
