Installation
To install the TRAC-Lock BT:
1. Remove the lid from the electronics enclosure and
unplug the four-prong connector.
2. Using the drill template, mark the four mounting
holes and the one center wire feed hole on the
exterior side of the door. Drill the four mounting
holes 9/16 in. (14 mm) and the center wire feed hole
5/8 in. (16 mm) through the door.
Note:
If you are drilling a metal door, be sure to
file the rough edges of the drill holes or use a
countersink drill.
3. Install the new lockset using the instructions
provided by the manufacturer. Thread the two-wire
plug from the lockset, through the door and through
the interior 5/8 in. (16 mm) wire feed hole.
4. Feed the four-wire plug from the exterior TRAC-Lock
BT plate through the 5/8 in. (16 mm) hole drilled in
the door and secure the interior mounting plate to
the exterior TRAC-Lock BT plate (Figure 3).
Note:
The white ferrite snap bead is not required
for TRAC-Lock. Installer may discard. Also,
Common Wire from Bezel is not required.
Installer may remove or leave in bezel.
5. Insert and tighten screws through interior plate. For
1-1/4 to 1-1/2 in. (32 to 38 mm) doors, use 3/4 in.
(19 mm) screws. For 1-1/2 to 2 in. (32 to 51 mm),
use 1-1/4 in. (38 mm) screws.
Note:
If the screw does not fully secure the plates
to the door when tightened, use a shorter screw.
Do not overtighten the long screw.
6. Thread the four-wire plug from the exterior TRAC-
Lock BT plate, and the two-wire plug from the
lockset through the wire feed hole in the electronics
enclosure. You will attach the wires after securing
the enclosure.
7. Use the four #8 × 5/16 in. (8 mm) pan head screws
and lock washers to attach the electronics enclosure
to the interior mounting plate. Insert and tighten the
screws and lock washers securely.
8. Attach the two-wire plug to the two prong connector.
Attach the four-wire plug to the four-wire connector.
9. Insert and connect the three 9-volt batteries to the
battery terminal connectors. Secure the batteries in
the battery holder compartment and make sure the
wires point toward you as you secure them in place.
(Battery connectors should point toward the circuit
board).
10. Perform an Install function with a valid TRACcess
eKEY. Refer to the TRACcess eKEY user
instructions for step by step operation.
11. Test the lock operation using the TRACcess eKEY.
Refer to the TRACcess eKEY user instructions for
step by step operation. Test the lock first with the
door open and then with the door shut to ensure the
lock strike catches the door frame.
12. Once you have tested the lock, place the lid on
the back of the electronics enclosure and position
the logo directly over the battery pack. Insert the
Figure 3. TRAC-Lock BT assembly
Figure 2. TRAC-Lock BT wood door installation
Electronics
Enclosure
Exterior
TRAC-Lock
BT Plate
Interior
Mounting
Plate
Electronics
Enclosure Lid
Lockset
2-wire plug
4-wire plug
