Introduction
This is the
Supra TRAC-Lock BT Installation
Instructions
. Read these instructions and the lockset
installation instructions before installing TRAC-Lock BT.
If you do not mount the TRAC-Lock BT accurately, it
will not function properly. Supra will not be responsible
for replacing the TRAC-Lock BT if it is damaged or
destroyed upon removal.
Installation supplies provided
• Installation instructions
• Drill template
• Electronics enclosure with lid
• Mounting plate (interior)
• Exterior TRAC-Lock BT plate
• Three 9-volt batteries
• Two sets of four #8 flat head screws (Two
different screw lengths for the mounting plate)
• Last battery change sticker
• One electrified lockset (no lock core)
• Four #8 × 5/16 in. (8mm) pan head screws and
lock washers (for electronics enclosure)
• Six #4 × 1/2 in. (13mm) flat head screws
• Plastic weather cover assembly
CAUTION:
The electronics in this package are
electrostatic sensitive devices. Before you install
the unit, discharge or use a grounding belt.
Installation tools required
• Drill
• Drill bits
• File
• Phillips screwdriver
• Level or punch
• Pen or pencil
P/N 10103023P1 Rev B • January 2012
© 2011 UTC Fire & Security. All rights reserved.
TRAC-Lock BT
Installation Instructions
Hardware not provided
When a lockset is provided with the TRAC-Lock BT,
the lockset will not include a lock core. If you install the
TRAC-Lock BT into a door that has a noncylindrical lock
(for example, a mortise lock), you will need additional
hardware. Consult a locksmith for the parts you need for
the conversion.
Figure 1. Standard TRAC-Lock BT installation
Installation notes
The TRAC-Lock BT is designed to be installed above,
below, or to the side of the lockset (Figure 1). We
recommend 6 in. (15 cm) above the lockset, or as far
above the lockset as needed to be out of the way of door
hardware. To meet ADA requirements, the lockset must
be no higher than 48 in. (120 cm) from the ground to
center of the device.
If you install the TRAC-Lock BT in a wood door, align it
horizontally with the lockset and latch (Figure 2). When
drilling, drill the latch set hole through the backset hole
and into the door. You will use this hole to thread the
wiring from the lockset to the TRAC-Lock BT. Align the
TRAC-Lock drill template (PN: 43336) so that the 5/8
in. (16 mm) wire feed hole intersects with the horizontal
hole. Use this channel to feed the wire from the lockset
to the TRAC-Lock BT. When you install the lockset, allow
room for expansion in hot weather.
