Superrollo GW70, Перевод оригинального руководства по эксплуатации и сборке

Страница: 21 / 40

21
EN
Additional information about configuring the end
points
The end points must be configured for the roller shutters
to stop at the desired upper and lower positions.
It is imperative that both end points are configured,
otherwise malfunctions may occur.
11. End point adjustment
Set the upper end point
i
i
The set button is slightly recessed in the front
panel. Please use a thin pen or similar tool in
order to press the set button.
1.
+ Simultaneously press and hold the
buttons.
The roller shutter travels up.
1.1
Tighten the belt slightly, until it is tensioned by the
weight of the roller shutters.
2.
+ Release the buttons, as soon as the
roller shutter reaches the desired
position for the upper end point.
The roller shutters stop and the upper
end point is stored.
ATTENTION!
Setting the wrong upper end point may lead
to overload or damage the superrollo GW70
or the drive
◆
Do not set the upper end point right up to
the limit stop. .
◆
Release the button promptly and never allow
it to extend beyond the respective end point.