Supero SUPER S2DM3, Руководство пользователя

Страница: 33 / 94

Chapter 2: Installation
2-5
Installation
2-4 Installing DIMMs
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
DIMM Installation (See Figure 2-3)
1. Insert DIMMs as required for the desired system memory. Note that the
S2DM3/S2DME interleaves memory for increased performance, which
requires you to install two modules at a time.
2. Insert each DIMM module vertically into its slot. Pay attention to the
two notches along the bottom of the module to prevent inserting the
DIMM module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. As stated in 1 above, you must populate either two or
four banks of memory.
Support
The S2DM3/S2DME supports registered DIMMs and ECC type memory.
PC133 and PC100 memory are both supported but will result in the
same perfomance, as the memory bus runs at 100 MHz.
Figure 2-3. DIMM Installation
Note: Notches
should align
with the
receptive points
on the slot
D I M M S l o t
Side View of DIMM Installation into Slot
DIMM
P C 1 0 0
Notches
P C 1 0 0
Notches
To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the two notches.