Supero 5025M-4 Plus, Руководство пользователя

Страница: 68 / 146

6-10
S
UPER
S
ERVER 5025M-4+/5025M-i+ Manual
6-5 Power Supply
The SuperServer 5025M-4+/5025M-i+ has a single 550 watt power supply. This
power supply module has an auto-switching capability, which enables it to automati-
cally sense and operate at a 100V to 220V input voltage.
Power Supply Failure
If the power supply fails, the system will shut down and you will need to replace the
power supply unit. Replacement units can be ordered directly from Supermicro.
See contact information in Chapter 1.
Removing/Replacing the Power Supply
Replace the failed power supply module with the same model (p/n PWS-0047),
which can be ordered directly from Supermicro (see Contact Information in the
Preface).
1. Removing the power supply
First shut down the system, then unplug the power cord. Remove the chassis cover
by pressing the two release buttons on the top of the chassis (near the front) then
push the chassis top rearward about one inch and lift it off. To remove the failed
power supply, remove the screws at the back that secure it to the chassis and pull
the unit straight out with the rounded handle.
2. Installing a new power supply
Replace the failed hot-swap unit with another power supply unit (p/n PWS-0047).
Push the new power supply unit into the power bay until you hear a *click*. Secure
the power supply with the screws you removed previously and fi nish by plugging in
the AC power cord.