4 /
/ 5
1.
Air Escape Ports.
2.
Nutrient Cap.
3.
Safety Cord.
4.
Diffuser/Filter.
5.
Tray.
6.
Aqueduct.
7.
Manifold/Blower Adapter.
8.
Air Blower.
9.
1:100 Injector Reservoir
10.
120v ALCI Protected Plug.
11.
90° Barbed Fitting.
12.
Drain Valve.
13.
Flex Drain Hose.
14.
¾ inch Top Hat Rubber Grommet.
15.
Manifold/Injector.
16.
Shuttle Valve.
17.
Main Reservoir
18.
Communication Apertures.
4
5
6
17
18
16
3
14
12
13
2
1
15
SIMPLE SET UP
1
Place system on a smooth, level surface that can
support the distributed weight of Turbo Grow.
• 38 L Turbo Grow - 70 kg
• 160 L Turbo Grow - 325 kg
2
Insert a
3
⁄
4
inch rubber grommet into the pre-drilled
7
⁄
8
inch hole on the tray surface, (a bit of dish soap
helps). Push and twist in the smaller end of the
shuttle valve
1
⁄
2
inch into the grommet. Face the holes
at top of the shuttle valve toward center of tray.
3
Insert the manifold/injector into the Turbo Grow
as shown by placing a
3
⁄
4
inch rubber grommet into
the tray’s drain hole. Next place a
3
⁄
4
inch rubber
grommet into the
7
⁄
8
inch manifold/injector hole
(located at the bottom on the opposite side of the
blower). A bit of dish soap applied to both rubber
grommets helps insertion. Press the
3
⁄
4
inch straight
barbed fitting into the manifold/injector. Hook the
manifold/injector over the top edge of the tray, then
press the manifold/injector into the system’s drain
hole grommet. Press until both sides go in all the way.
8
7
11
10
9
