Supermicro SuperWorkstation 5037A-iL-MA015, Руководство пользователя

Страница: 17 / 48

Chapter 2: Workstation Setup
2-5
ME Manufacturing Mode (JPME2)
Close pins 2-3 of JPME2 to enable ME Manu-
facturing Mode. See the table on the right for
jumper settings. ote: ME Manufacturing Mode
may be enabled without changing this jumper
through the BIOS setup. See PCH-FW Con-
fi guration -> Firmware Update Confi guration in
the BIOS Setup. The /ME parameter must be
specifi ed when updating with the DOS utility.
JPME2
Jumper Settings
Both Jumpers Defi nition
Pins 1-2 Disabled
Pins 2-3 Enabled
Audio Enable/Disable
Jumper Settings
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Audio Enable (JPAC1)
JPAC1 allows you to enable or disable the
onboard audio support. The default position
is on pins 1 and 2 to enable onboard audio
connections. See the table on the right for
jumper settings.
Watch Dog Timer Reset (JWD1)
Watch Dog Timer Reset (JWD1) is a system
monitor that can reboot the system when a
software application hangs. Close Pins 1-2
to reset the system if an application hangs.
Close pins 2-3 to generate a non-maskable
interrupt signal for the application that hangs.
See the table on the right for jumper settings.
Watch Dog must also be enabled in the BIOS.
Watch Dog Timer Reset
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
USB Wake-Up (JPUSB1/JUSB2)
Use the JPUSB jumpers to enable system
"wake-up" via a USB device. These jumpers
allow you to "wake-up" the system by pressing
a key on the USB keyboard or by clicking the
USB mouse of your system. The JPUSB jump-
ers are used together with the USB Wake-Up
function in the BIOS. Enable both the jumper
and the BIOS setting to activate this function.
See the table on the right for jumper settings
and jumper connections. Use JUSB1 for back
panel USB ports and JUSB2 for front panel
USB headers/ports.
USB Wake-Up
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled (Default)