Supermicro SuperServer SYS-210TP-HPTR, Руководство пользователя

Страница: 95 / 153

95
Chapter 7: Troubleshooting and Support
No Power
•
Check that the power LED on the motherboard is on.
•
Make sure that the power connector is connected to the power supply.
•
Check that the motherboard battery still supplies approximately 3VDC. If it does not, re-
place it.
•
Check that the system input voltage is 100-127Vac or 200-240Vac, 50-60Hz.
•
Turn the power switch on and off to test the system
Figure 7-3. Location of the MB Power LED
LEDPWR
BAR CODE
PCH
LAN
CTRL
FAN4
BIOS
LICENSE
REV:1.01
X12DPT-PT46
DESIGNED IN USA
BMC
FAN3
JSD1
I-SA
TA4
CPLD1
JPTG1 JP
AUX1
JPME2
JHS1
SXB6
I-SATA5
JSD2
LEDM1
LEDPWR
USB0/1
(
3.2 Gen 1
)
S-SA
TA0~5
LAN2
LAN1
COM1
UID-LED
JUIDB1
BMC_LAN
VGA
CPU1 SXB6 PCI-E 4.0 X8
JRK1
JIPMB1
CPU1
CPU2
P2-DIMMC1 P2-DIMMD1 P2-DIMMA1 P2-DIMMB1
SXB1
CPU1 SXB1 PCI-E 4.0 X8
P2-DIMMF1 P2-DIMME1 P2-DIMMH1 P2-DIMMG1
SXB5
CPU1 SXB5 PCI-E 4.0 X8
P1-DIMMG1 P1-DIMMH1 P1-DIMME1 P1-DIMMF1 P1-DIMMB1 P1-DIMMA1 P1-DIMMD1 P1-DIMMC1
JBT1
JTPM1
JNCSI1
SXB3
CPU1 SXB3 PCI-E 4.0 X16
SXB4
CPU2 SXB4 PCI-E 4.0 X16
BT1
MAC CODE IPMI CODE
7.3 Troubleshooting Procedures
Use the following procedures to troubleshoot your system. If you have followed all of the
procedures below and still need assistance, refer to the
Technical Support Procedures or
Returning Merchandise for Service sections in this chapter. Power down the system before
changing any non hot-swap hardware components.
General Technique
If you experience unstable operation or get no boot response, try:
1. With power off, remove all but one DIMM and other added components, such as add-on
cards, from the motherboard. Make sure the motherboard is not shorted to the chassis.
2. Set all jumpers to their default positions.
3. Power up. If the system boots, check for memory errors and add-on card problems.