Supermicro SUPERSERVER 6011H, Руководство пользователя

Страница: 107 / 112

B-7
Appendix B: AMIBIOS POST Diagnostic Error Codes
Checkpoint Code Description
executing the AMIBIOS Setup or WINBIOS Setup utility
next.
88h Returned from WINBIOS Setup and cleared the screen.
Performing any necessary programming after WINBIOS
Setup next.
89h The programming after WINBIOS Setup has completed.
Displaying the power on screen message next.
8Bh The first screen message has been displayed. The
<WAIT...> message is displayed. Performing the PS/2
mouse check and extended BIOS data area allocation
check next.
8Ch Programming the WINBIOS Setup options next.
8Dh The WINBIOS Setup options are programmed. Resetting
the hard disk controller next.
8Fh The hard disk controller has been reset. Configuring the
floppy drive controller next.
91h The floppy drive controller has been configured.
Configuring the hard disk drive controller next.
95h Initializing the bus option ROMs from C800 next. See the
last page of this chapter for additional information.
96h Initializing before passing control to the adaptor ROM at
C800.
97h Initialization before the C800 adaptor ROM gains control
has completed. The adaptor ROM check is next.
98h The adaptor ROM had control and has now returned
control to BIOS POST. Performing any required
processing after the option ROM returned control.
99h Any initialization required after the option ROM test has
completed. Configuring the timer data area and printer
base address next.
9Ah Set the timer and printer base addresses. Setting the
RS-232 base address next.
9Bh Returned after setting the RS-232 base address.
Performing any required initialization before the
coprocessor test next.
9Ch Required initialization before the Coprocessor test is
over. Initializing the coprocessor next.
9Dh Coprocessor initialized. Performing any required
initialization after the Coprocessor test next.
9Eh Initialization after the Coprocessor test is complete.
Checking the extended keyboard, keyboard ID, and