Supermicro SuperBlade SBM-GEM-X2C+, Руководство пользователя

Страница: 277 / 404

7-149
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Clicking the N
EIGHBORS
tab brings up the BGP P
EER
C
ONFIGURATION
page
( Figure 7-130 ), which allows you to configre BGP Neighbors. The parameters for this
page are shown in Table 7-103 .
BGP MED Configuration
Table 7-103. BGP Peer Configuration Page Parameters
Parameter Description
IP Address This parameter specifies the IP address of the BGP neighbor.
EBGP MultiHop
By enabling this feature, BGP connections can be established between
peers, which are not directly connected.
Next Hop
Using this parameter, next Hop can be set as Self or Automatic . By setting
this field to Self , you can make the switch the next hop for all the routes
that it distributes to its peers.
Keep Alive Time (Seconds)
This parameter specifies the maximum time interval between successive
updates between any two BGP peers.
Hold Time (Seconds)
This parameter specifies the Hold time. This is the timer interval that a
BGP will wait, before it decides that a connection to the peer is torn down.
Remote AS This parameter represents the remote autonomous system number.
Advertisement Interval
(seconds) This parameter specifies the interval in seconds for the Minimum Route
advertisement interval timer.
Status This parameter specifies the status of the entry.
Figure 7-131. BGP MED Configuration Page