Supermicro SuperBlade SBM-GEM-X2C+, Руководство пользователя

Страница: 187 / 404

7-59
Chapter 7: Layer 2/3 Ethernet Switch Firmware
The following pages are available for configuring Stack settings;
• "Stack Configuration" on page 7-59
• "Stack Details" on page 7-60
• "Stack Counters" on page 7-62
Stack Configuration
Clicking the S
TACK
S
ETTINGS
tab brings up the S
TACK
C
ONFIGURATION
page
( Figure 7-49 ), which configures the stacking feature. The parameters for this page are
shown in Table 7-35 .
Figure 7-49. Stack Configuration Page
Table 7-35. Stack Configuration Page Parameters
Parameter Description
Switch ID
This parameter defines a switch identifier number for this switch. This
identifier should be unique in the stack, since the number is used in
referring all physical interfaces available in this switch.
So for example, if this parameter is choosen as 2 , the physical interfaces
will be referred as Gi2/1 , Gi2/1 and so on.
For non-stacking, stand-alone cases this switch ID is considered as zero .
Ports
This parameter represents the number of stacking ports. You can choose
the number based upon your preferred stacking configuration and
available CX4 ports. It is recommended that you use two CX4 ports as
stacking ports to get redundancy.