Supermicro SuperBlade SBA-4119S-C2N, Руководство пользователя

Страница: 58 / 86

58
SuperBlade Server SBA-4119S-(C/T)2N User's Manual
BIOS POST Messages
BIOS Message Description
Previous boot incomplete -
Default configuration used
Previous POST did not complete successfully. POST loads default values
and offers to run Setup. If the failure was caused by incorrect values and
they are not corrected, the next boot will likely fail. On systems with control of
wait states, improper Setup settings can also terminate POST and cause this
error on the next boot. Run Setup and verify that the waitstate configuration is
correct. This error is cleared the next time the system is booted.
Memory Size found by POST
differed from CMOS
Memory size found by POST differed from CMOS.
Diskette drive A error
Diskette drive B error
Drive A: or B: is present but fails the BIOS POST diskette tests. Check to see
that the drive is defined with the proper diskette type in Setup and that the
diskette drive is attached correctly.
Incorrect Drive A type - run
SETUP
Type of floppy drive A: not correctly identified in Setup.
Incorrect Drive B type - run
SETUP
Type of floppy drive B: not correctly identified in Setup.
System cache error - Cache
disabled
RAM cache failed and BIOS disabled the cache. On older boards, check
the cache jumpers. You may have to replace the cache. See your dealer. A
disabled cache slows system performance considerably.
CPU ID: CPU socket number for Multi-Processor error.
EISA CMOS not writeable ServerBIOS2 test error: Cannot write to EISA CMOS.
DMA Test Failed
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory
Access) registers.
Software NMI Failed
ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable
Interrupt).
Fail-Safe Timer NMI Failed ServerBIOS2 test error: Fail-Safe Timer takes too long.
device Address Conflict Address conflict for specified device.
Allocation Error for: device
Run ISA or EISA Configuration Utility to resolve resource conflict for the
specified device.
CD ROM Drive CD ROM Drive identified.
Entering SETUP... Starting Setup program
Failing Bits: nnnn
The hex number nnnn is a map of the bits at the RAM address which failed the
memory test. Each 1 (one) in the map indicates a failed bit. See errors 230,
231, or 232 above for offset address of the failure in System, Extended, or
Shadow memory.
Fixed Disk n Fixed disk n (0-3) identified.
Invalid System Configuration
Data
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict I/O device IRQ conflict error.
PS/2 Mouse Boot Summary
Screen:
PS/2 Mouse installed.