Supermicro SSE-G2252, Руководство пользователя

Страница: 1275 / 1401

Chapter 41: CFM Commands
– 1289 –
interval-level – The transmission delay between connectivity check
messages. The setting for this parameter is expressed as levels 4
through 7, which in turn map to specific intervals of time.
(CCM lifetime field options: 4 - 1 second, 5 - 10 seconds,
6 - 1 minute, 7 - 10 minutes).
D
EFAULT
S
ETTING
4 (100 ms)
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
•
CCMs provide a means to discover other MEPs and to detect
connectivity failures in an MA. If any MEP fails to receive three
consecutive CCMs from any other MEPs in its MA, a connectivity failure
is registered. The interval at which CCMs are issued should therefore be
configured to detect connectivity problems in a timely manner, as
dictated by the nature and size of the MA.
•
The maintenance of a MIP CCM database by a MIP presents some
difficulty for bridges carrying a large number of Service Instances, and
for whose MEPs are issuing CCMs at a high frequency. For this reason,
slower CCM transmission rates may have to be used.
E
XAMPLE
This example sets the transmission delay for continuity check messages to
level 7 (60 seconds).
Console(config)#ethernet cfm cc md voip ma rd interval 7
Console(config)#
R
ELATED
C
OMMANDS
ethernet cfm cc enable (1289)
ethernet cfm cc
enable
This command enables the transmission of continuity check messages
(CCMs) within a specified maintenance association. Use the no form to
disable the transmission of these messages.
S
YNTAX
[ no ] ethernet cfm cc enable md domain-name ma ma-name
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-43
alphanumeric characters)
D
EFAULT
S
ETTING
Disabled