Supermicro SSE-G2252, Руководство пользователя

Страница: 1246 / 1401

Chapter 40: LLDP Commands
– 1259 –
•
For the location options defined for device-type , normally option 2 is
used to specify the location of the client device. In situations where the
client device location is not known, 0 and 1 can be used, providing the
client device is physically close to the DHCP server or network element.
E
XAMPLE
The following example enables advertising location identification details.
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-location civic-addr
Console(config-if)#lldp med-location civic-addr 1 California
Console(config-if)#lldp med-location civic-addr 2 Orange
Console(config-if)#lldp med-location civic-addr 3 Irvine
Console(config-if)#lldp med-location civic-addr 4 West Irvine
Console(config-if)#lldp med-location civic-addr 6 Exchange
Console(config-if)#lldp med-location civic-addr 18 Avenue
Console(config-if)#lldp med-location civic-addr 19 320
Console(config-if)#lldp med-location civic-addr 27 5
Console(config-if)#lldp med-location civic-addr 28 509B
Console(config-if)#lldp med-location civic-addr country US
Console(config-if)#lldp med-location civic-addr what 2
Console(config-if)#
lldp
med-notification
This command enables the transmission of SNMP trap notifications about
LLDP-MED changes. Use the no form to disable LLDP-MED notifications.
S
YNTAX
[ no ] lldp med-notification
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
•
This option sends out SNMP trap notifications to designated target
stations at the interval specified by the lldp notification-interval
command. Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or
organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
•
SNMP trap destinations are defined using the snmp-server host
command.
•
Information about additional changes in LLDP neighbors that occur
between SNMP notifications is not transmitted. Only state changes that
exist at the time of a trap notification are included in the transmission.
An SNMP agent should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.