Supermicro SSE-G2252, Руководство пользователя

Страница: 1097 / 1401

Chapter 36: VLAN Commands
Configuring IP Subnet VLANs
– 1110 –
D
EFAULT
S
ETTING
The mapping for all interfaces is displayed.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
This shows that traffic entering Port 1 that matches the specifications for
protocol group 1 will be mapped to VLAN 2:
Console#show interfaces protocol-vlan protocol-group
Port ProtocolGroup ID VLAN ID
---------- ------------------ -----------
Eth 1/1 1 vlan2
Console#
C
ONFIGURING
IP S
UBNET
VLAN
S
When using IEEE 802.1Q port-based VLAN classification, all untagged
frames received by a port are classified as belonging to the VLAN whose
VID (PVID) is associated with that port.
When IP subnet-based VLAN classification is enabled, the source address of
untagged ingress frames are checked against the IP subnet-to-VLAN
mapping table. If an entry is found for that subnet, these frames are
assigned to the VLAN indicated in the entry. If no IP subnet is matched, the
untagged frames are classified as belonging to the receiving port’s VLAN ID
(PVID).
subnet-vlan
This command configures IP Subnet VLAN assignments. Use the no form to
remove an IP subnet-to-VLAN assignment.
S
YNTAX
subnet-vlan subnet ip-address mask vlan vlan-id [ priority priority ]
no subnet-vlan subnet { ip-address mask | all }
ip-address – The IP address that defines the subnet. Valid IP
addresses consist of four decimal numbers, 0 to 255, separated by
periods.
mask – This mask identifies the host address bits of the IP subnet.
Table 36-10: IP Subnet VLAN Commands
Command Function Mode
subnet-vlan Defines the IP Subnet VLANs GC
show subnet-vlan Displays IP Subnet VLAN settings PE