Supermicro SC826A-R1200LPB, Руководство пользователя

Страница: 50 / 134

SC826 Chassis Manual
4-12
4-5 Installing Expansion Cards
For the LP models, such as SC826BE1C-R920LPB, the chassis slots are vertical
and allow the addition of low profile expansion cards. For the W models such as
SC826BE1C-R920WB, and the U models such as SC826E16-R1200UB, the chas-
sis slots are horizontal. The U models allow a Supermicro universal I/O (UIO) card
in addition to expansion cards.
The motherboard must be installed before expansion cards.
Expansion Cards for an LP Model Chassis
The LP model chassis includes seven slots for expansion cards.
Installing an Expansion Card for an LP Model Chassis
1. Power down the system as described in Section 4-1 and remove the cover.
2. In the rear of the chassis, remove the blank PCI shield that is pre-installed
covering the expansion slot.
Figure 5-11. Remove an LP Expansion Card Slot Shield
3. Slide the expansion card into the expansion slot on the motherboard while
aligning it with the chassis slot in the rear of the chassis.
4. Secure the expansion card shield onto the rear of the chassis with a screw.
Expansion Cards for a W or U Model Chassis
The W or U model chassis accomodates expansion cards using riser cards. If your
motherboard supports a Supermicro universal I/O (UIO) card, the U model chassis
supports an additional three full-height expansion cards and three low profile expan -
sion cards. If the motherboard does not support a UIO, then the W model chassis
supports four full-height expansion cards and three low profile expansion cards.
Chassis Expansion
Card Slots