Supermicro SBI-7127RG, Руководство пользователя

Страница: 49 / 88

3-17
Chapter 3: Setup and Installation
7. Attach retention brackets to the back of each of the GPU cards with two (2) screws
each (see
Figure 3-21 ). Also unscrew the retention bracket screws from the module
serverboard for assembly installation into the bottom blade chassis.
Note: The SBI-7127RG blade module uses a different size and type of brackets for each
of the GPUs installed in the module. Use (part # MCP-640-00063-0N) for the right GPU
and (part # MCP-640-00062-0N) for the left GPU (for the orientation as shown in
Figure 3-21 above).
8. (Optional) Install the SATA DOM module and its associated power cable before
replacing the front assembly back on the blade module at this time. See
"Hard Disk
Drives" on page 4-8 for details.
9. Reattach the Riser Card/Front Blade Assembly back into the blade module.
Resecure it with its fourteen (14) retaining screws and screw the two retention
bracket screws to the GPUs and the serverboard (see
step 7 ).
10. Install the two GPU card power cables for each GPU card. One end attaches to the
GPU card’s 8-pin socket, the other end attaches to the power socket on the blade
module’s serverboard.
11. Replace the top cover and secure it with its one retention screw (see Figure 3-16 ).
Figure 3-21. Attaching Retention Brackets to GPU Cards