Supermicro MicroBlade MBI-6119G-T7LX, Руководство пользователя

Страница: 34 / 76

MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade Module User’s Manual
3-4
3-4 Memory Installation
The serverboard of each MicroBlade module unit must be populated with DIMMs (Dual
In-line Memory Modules) to provide system memory.
The DIMMs should all be of the
same size and speed and from the same Super Micro authorized manufacturer
due to compatibility issues.
See details below on supported memory and our web site
( www.superblade.com/products/microblade for recommended memory.
Populating Memory Slots
The mainboard of a MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade module has two
(2) memory slots for each processor of a node, up to two nodes total for a total of four
(4) memory slots per MicroBlade module. Both interleaved and non-interleaved memory
are supported, so you may populate any number of DIMM slots.
Each of the nodes has its own memory bank. Populate Channel A first, the Channel B.
In this example, Channel A of Node 1 is designated as P1-DIMMA1 and Channel B is
P1-DIMMB1. Be sure to populate the sockets with SODIMM memory with the same
speed.
For an interleaved configuration, memory modules of the same size and speed
must be installed in pairs. You should not mix DIMMs of different sizes and
speeds.
Note: Check the Supermicro website for a list of memory modules that have been
validated with the B2SS1-MTF/B2SS2-MTF motherboard.
Note: Though multiple DIMM memory module types and speeds may be supported, you
need to use DIMM memory modules of the same speed and type.
Memory Support
Each node on the B2SS1-MTF/B2SS2-MTF motherboard supports up to 32GB of
1600MHz of ECC DDR4 SODIMM memory in two SODIMM slots (see
Figure 3-3 ).
Figure 3-3. SO DIMM Sideways View
1
P1-DIMMA1
P1-DIMMB1