Supermicro MBI-6128R-T2, Руководство пользователя

Страница: 39 / 81

3-9
Chapter 3: Setup and Installation
3-5 Memory Installation
The motherboard of each blade unit must be populated with DIMMs (Dual In-line
Memory Modules) to provide system memory.
The DIMMs should all be of the same
size and speed and from the same Super Micro authorized manufacturer due to
compatibility issues.
See details below on supported memory and our web site
( www.supermicro.com/products/superblade for recommended memory.
Populating Memory Slots
The motherboard of a MBI-6128R-T2/T2X blade module has eight (8) memory slots,
four for each processor. Both interleaved and non-interleaved memory are supported,
so you may populate any number of DIMM slots.
Populating two slots at a time ( DIMM2A, DIMM4A, etc.) with
memory modules of the same size and of the same type will result in dual-channel,
interleaved memory, which is faster than single-channel, non-interleaved memory. See
Table 3-1: "Populating Eight Memory Slots for Interleaved Operation" on page 3-9 for
details.
For an interleaved configuration, memory modules of the same size and speed
must be installed in pairs. You should not mix DIMMs of different sizes and
speeds.
Table 3-1. Populating Eight Memory Slots for Interleaved Operation
# of
DIMMs
CPU1 CPU2
Channel
A
Channel
B
Channel
C
Channel
D
Channel
E
Channel
F
Channel
G
Channel
H
4 X X X X
8 X X X X X X X X