Supermicro H8DGT-HLF, Руководство пользователя, Страница: 27 / 72

Chapter 2: Installation
2-5
3. Gently press down on the memory module until it snaps into place.
4. With four DIMMs installed, repeat step 2 to populate the CPU2 DIMM
slots. Always install four DIMMs to both CPU DIMM slots for more effi cient
operation.
Note: 1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It
is highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the H8DGT-HLF/HLIBQF serverboard.
Support
The H8DGT-HLF/HLIBQF serverboard supports single/dual/tri/quad-channel,
DDR3-1333/1066/800 registered ECC/Unbuffered ECC/non-ECC SDRAM.
Populating four adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
T h e H 8 D G T - H L F / H L I B Q F s e r v e r b o a r d s u p p o r t s u p t o
32 GB of ECC/Non-ECC UDIMM or up to 128 GB of ECC RDIMM SDRAM in
eight (8) DIMM slots.
Figure 2-1. DIMM Installation
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should align
with the receptive key
point on the slot.
Notch
Notch
Front View