FatTwin AS -F2014S-RNTR User's Manual
38
3.5 System Nodes
Installing and Removing Hard Drives
Removing Hard Drive Carriers from the Node
1. Press the release button on the drive carrier. This extends the drive bay handle.
2. Use the handle to pull the drive carrier out of the chassis.
Figure 3-5. Removing a Hard Drive Carrier (rear drives shown)
Release button
Installing a Hard Drive into a Drive Carrier
1. Insert a drive into the carrier with the PCB side facing down and the connector end
toward the rear of the carrier.
2. Align the drive in the carrier so that the screw holes of both line up. Note that there are
holes in the carrier marked “SATA” to aid in correct installation.
3. Secure the drive to the carrier with four screws.
4. Insert the drive carrier into its bay, keeping the carrier oriented so that the hard drive
is on the top of the carrier and the release button is on the right side. When the carrier
reaches the rear of the bay, the release handle will retract.
5. Push the handle in until it clicks into its locked position.