10
AS-2113S-WN24RT User's Manual
Control Panel Features
Item Feature
Description
1
Power Button
The main power switch is used to apply or remove power to the server.
Turning off system power with this button removes the main power but keeps
standby power supplied to the system (you must unplug the AC power cord
before servicing.
2
Reset Button
Resets (reboots) the system
3
Power LED
Indicates power is being supplied to the system's power supply units. This LED
should normally be illuminated when the system is operating.
4
NIC2 LED
Indicates network activity on LAN2 when flashing.
5
Power Fail LED
Indicates a power supply fan failure. An alarm will also sound, which can be
turned off with the reset switch on the back of the power supply.
6
HDD LED
Indicates hard drive activity when flashing.
7
NIC1 LED
Indicates network activity on LAN1 when flashing.
8
Universal Information
LED
See the following table for the status shown by this LED.
Figure 1-1. Control Panel View
1.4 Server Chassis Features
Control Panel
There are two buttons located on the front of the chassis: a power on/off button and a UID
button. In addition there are five LEDs. The locations of these buttons and LEDs on the control
panel are described below. See Chapter 4 for details on the control panel connections.
2
1
7
8
6
5
4
3
Universal Information LED
Status
Description
Continuously on and red
An overheat condition has occurred. (This may be caused by cable congestion.)
Blinking red (1 Hz)
Fan failure: check for an inoperative fan.
Blinking red (0.25 Hz)
Power failure: check for an inoperative power supply.
Solid blue
UID has been activated locally to locate the server in a rack environment.
Blinking blue (300 msec)
UID has been activated using IPMI to locate the server in a rack environment.