A+ Server AS -1114S-WTRT User's Manual
44
Power Supply
The AS -1114S-WTRT has a redundant, hot-plug 500W power supply consisting of two power
modules. Each power supply module has an auto-switching capability, which enables it to
automatically sense and operate at a 100V - 240V input voltage.
Power Supply Failure
If either of the two power supply modules fail, the other module will take the full load and allow
the system to continue operation without interruption. The PWR Fail LED will illuminate and
remain on until the failed unit has been replaced. Replacement units can be ordered directly
from Supermicro (see contact information in the Preface). The hot-swap capability of the power
supply modules allows you to replace the failed module without powering down the system.
Replacing the Power Supply
1. Check the LEDs on the power supplies to determine which module has failed.
2. Unplug the power cord from the failed module.
3. Push the release tab (on the back of the power supply) as illustrated, then pull the
power supply out using the handle provided.
4. Push the new power supply module into the power bay until you hear a click (replace
with the same model: p/n PWS-504P-1R).
5. Reconnect the power cord to the new module.
Release Tab
Figure 3-21. Replacing the Power Supply
Note:
The figures above is intended to show the power supply locations only. The chassis and
serverboard may differ from that found in the AS -1114S-WTRT.
