Supermicro 6038R-E1CR16H, Руководство пользователя

Страница: 49 / 81

Chapter 6: Advanced Chassis Setup
6-9 6-8
S
UPER
S
TORAGE
S
YSTEM 6038R-E1CR16H User's Manual
Hard Drive Backplane
The hard drives plug into a backplane that provides power, drive ID and bus termina -
tion. The backplane is already preconfigured, so no jumper or switch configurations
are required.
Figure 6-6. Mounting a Drive in a Carrier
Important: Regardless of how many hard drives are installed, all drive carriers must
remain in the drive bays to maintain proper airflow.
Caution: Use caution when working around the backplane. Do not touch the backplane
with any metal objects and make sure no ribbon cables touch the backplane or obstruct
the holes, which aid in proper airflow.
6-7 Power Supply
The 6038R-E1CR16H has a 920 watt redundant power supply consisting of two hot-
plug power modules. Each power supply module has an auto-switching capability,
which enables it to automatically sense and operate at a 100V - 240V input voltage.
Power Supply Failure
If either of the two power supply modules fail, the other module will take the full
load and allow the system to continue operation without interruption. The Power
Fail LED on the front control panel will illuminate and remain on until the failed unit
has been replaced.
Replacement units can be ordered directly from Supermicro. The power supply
units have a hot-swap capability, meaning you can replace the failed unit without
powering down the system.
Removing/Replacing the Power Supply
You do not need to shut down the system to replace a power supply unit. The
backup power supply module will keep the system up and running while you replace
the failed hot-swap unit. Replace with the same model (see part number in the Ap-
pendix), which can be ordered directly from Supermicro.
Removing the Power Supply (Figure 6-7)
1. First unplug the AC power cord from the failed power supply module.
2. Depress the locking tab on the power supply module.
3. Use the handle to pull it straight out with the rounded handle.
Installing a New Power Supply
1. Replace the failed hot-swap unit with another identical power supply unit.
2. Push the new power supply unit into the power bay until you hear a click.
3. Secure the locking tab on the unit.
4. Finish by plugging the AC power cord back into the unit.