Supermicro 2020A-8R, Руководство пользователя

Страница: 66 / 102

6-8
A+ Server 2020A-8R User's Manual
Installing a Component in the 5.25" Drive Bay
1. Mounting a component in the drive carrier
A single 5.25" drive bay is located in the front of the chassis. A component such
as an additional IDE hard drive or a SCSI drive that can fi t into a standard IDE
drive bay can be mounted in this 5.25" drive bay. A component added to this bay
should be mounted in a drive tray.
To add a component such as those noted above, install a drive into the tray with
the printed circuit board side toward the carrier (facing down) so that the mounting
holes align with those in the side of the tray. Secure the drive to the carrier with
the four screws.
2. Installing/removing 5.25" drive bay component
A component mounted in this drive bay is not hot-swappable, meaning system power
must be turned off before installing and/or removing it.
To remove the component, fi rst power down the system and then remove the top
cover of the chassis. Unscrew the retention screw at the top center of the drive,
then push the drive tray out from the back until you can grasp and pull it out through
the front of the chassis. If installing, attach the component to the tray as described
above. Then reverse the drive tray removal procedure to install the drive, mak-
ing sure you screw in the retention screw. Replace the top chassis cover when
fi nished.