21
5.2 Operator Menu
Each of the parameters in the operator Menu is configured in the same way. The
following procedure describes how to configure a typical setting:
1. Locate the desired parameter in the menu:
a) Press Menu until the desired parameter name appears in the LCD display.
2.
Press OK. “Enter Password 100” appears in the LCD display.
3. Enter the operator password 123 (or technician password 456; both are
accepted).
4. Press the up arrow or down arrow until the password number is reached.
5. Press OK to accept the password. Th
e parameter’s name and current setting
appear in the LCD display.
6. Press OK, again. The LCD display shows the parameter and the current setting.
7. Enter the new parameter setting:
a) Press the up arrow or down arrow until the desired value is reached.
b) The second row of the menu display, below the value that is being changed,
shows the current value.
8. Press Enter to save the new setting or Esc to abort without saving the new setting.
To change the settings of additional parameters, press menu until the desired
parameter appears in the LCD display. Repeat steps 6-8 above to set the new
parameter.
NOTE:
The factory-set operator password is 123. The operator password can be changed
in the technician menu (see technician menu setup).
NOTE:
Holding Menu while pressing up or down will advance the first digit. Holding up or
down for an extended period of time will proceed through the numbers more quickly.
NOTE:
The Menu button displays the next parameter in the list, so that the operator can
check every parameter in the menu. There is no scroll-back option. To view or
change a previous parameter in the menu, you must exit the menu by pressing
Esc, and start the above procedure from the beginning.
