5
INSTALLATION
ELECTRICAL CONNECTION
For your protection, we recommend that a qualified electrician install this appliance.
The electrician should be familiar with electrical installations and your local electrical requirements.
Proper connections and power supply are essential for efficient performance. The supply circuit
should be properly fused as required by local electrical code.
WARNING
Before making any electrical connection be sure to read data plate which is located on the
rear of the unit.
Electrical Grounding Instructions
This unit is equipped with a -prong (grounded) plug for your protection against shock hazard
and must be plugged directly into a properly grounded -prong receptacle.
CAUTION
DO NOT CUT OR REMOVE THIS PLUG OR GROUNDED PRONG FROM THE PLUG.
CONNECT/PLUG UNIT INTO DEDICATED A.C. LINE ONLY SPECIFIED ON THE DATA
PLATE OF THE UNIT.
WATER SUPPLY
These units come equipped with a cup water tank with tank drain and supply pump. It is
vital that all water supply lines be thoroughly flushed with clean water before being connected
to the steamer.
The Superior Fast-Steamer has a water injection system, to ensure your new equipment works at
its premium, we recommend that a water softener is used in areas where hard water is present.
Contact your local water equipment system provider to assist you in determining your specific
water quality, or contact Superior Technical support for assistance, -800-807-9054.
Reservoir Water Units
1. With unit in final position, open reservoir cover.
. Check and make sure the reservoir is free of debris and material that may interfere
with operation.
. Pour tap water into reservoir unit the water level is /4" from the top.
4. Slide door closed.
5. Check water level during daily operation and fill when needed.
PRESET TIME
If adjustments are required, please refer to the time programming section in this manual.
°F/°C CONVERSION
To change the temperature display from °F to °C or from °C to °F, hold the TEMP button
while the unit is turned off. While holding the TEMP button, turn the unit on. The display
will be the changed temperature mode. To change back, repeat the procedure.
