Installation
900079-02 05/2015
Innovative Hearth Products
Superior™ DRL3000 Linear Direct-Vent Gas Fireplaces
44
19.
Install the Wall Switch Receiver
1.
When wall finish is complete, install the wall switch receiver in the previously installed junction box, and connect
the 2-wire terminal to the connector on the back of the receiver.
2.
Install the receiver cover plate. Ensure the receiver switch is properly aligned with the switch cover
20.
Initialize the Remote Control System
After completing fireplace installation, initialize the remote control system before operating the fireplace. See the
Operation
section on
Page 51
for more details.
1.
Insert the three (3) provided
AAA
batteries into the battery bay in the remote control (
Figure 42
). Correctly align polarity (+/–).
2.
Insert the (4) provided
AA
batteries into the receiver battery bay (behind the wall switch plate). Correctly align polarity (+/–).
3.
Position the wall switch receiver three-position slider switch in the REMOTE position (
Figure 42
).
4.
On the remote control, press the ON button (
Figure 46
).
21.
Attach the Safety-in-Operation Warning Labels
1.
Attach the furnished safety instruction labels at all fireplace operation and control points (
Page 45
).
NOTE:
The installer MUST ensure these warnings are properly attached during installation. The warning labels are a
critical means of informing consumers of safe operation practices.
