8
SETTING UP THE DEVICE
•
Remove all stains and packing materials as well as all liners from the device.
•
ATTENTION! Check the device for any possible damages such as a poorly-
mounted or crooked door, damaged door seals and sealing surfaces, defects or
loose hinges and latches, dents on the inside or on the door. Also check for any
damages to the power cord / power plug. Do not use this device if damages are
present.
•
The microwave may only be placed on an even, stable and heat-resistant
surface which is suitable for bearing the weight of the device.
•
Do not place this device near sources of heat, near flammable or combustible
materials or in places where wetness or high humidity occurs.
•
The device must be adequately ventilated for proper operation. Make sure that
there is a distance of 20 cm from above, 10 cm from the back and 5 cm on each
of both sides. The openings of the device must not be covered or obstructed.
The legs of the device must not be removed.
•
Make sure that the power cord is undamaged and does not run under the
device or over hot or sharp-edged surfaces.
•
The power outlet must be easily accessible so that the power plug can be pulled
out without effort in case of emergency.
•
Do not use this device outdoors.
•
Do not use this device without its approved, properly inserted
glass plate (7)
and
rolling ring (3).
RADIO INTERFERENCE
Operating this microwave device can lead to interference to your radio, television
or similar devices. These disturbances can be minimised or eliminated using the
following measures:
•
Clean the door and sealing surfaces of the microwave device.
•
Reorient the reception antenna of the device which has been disturbed by the
microwave.
•
Change the location of the microwave device or the device which is being
disturbed by the microwave.
•
Connect the microwave device to another power outlet so that the microwave
device and the device being disturbed by the microwave are connected to
different power circuits.
INFORMATION ON GROUNDING
•
This device must be grounded.
•
This device must be connected only to an approved, properly installed,
grounded isolated receptacle power outlet. The power supply voltage must
correspond to the voltage specified on the name plate.
•
Setting up a separate power circuit only for this device is recommended.
10002124_D80D20EP_IM_V02_A120625_ktk_10-12-2012_GB.indd 8
10/12/2012 3:06 PM
