1. Motors are mounted with four Phillips head M3 x 8 screws. Apply a drop of liquid
thread locker to screws before installing.
2. Orient the motors so that the labels on the motor are easy to read when the motor is
installed. Loosely tighten the screws into place.
3. When the motor is close to being fully seated, tighten each screw evenly in a star
pattern so that the motor tightens down flush with the inside wall of the chassis.
7
6
SUPERDROIDROBOTS.COM
SUPERDROIDROBOTS.COM
Mechanical Assembly (Continued)
Some packages may require a two-person lift.
Wear appropriate protective gear during assembly.
May cause physical harm due to pinching.
1. Start with a clean open area that will allow the parts to be spread out before beginning
work.
2. Make sure that all parts are included in the packaging before starting to assemble.
If there are any missing components, please send us an email at [email protected].
Be sure to include an order number, and a well-defined list of any missing parts.
WARNING
Required Tools
• Phillips head screwdriver
• Crescent wrench
• Power Drill
• Allen wrench set
• Liquid thread lock
Hub Mount (see fig. 2a)
Wheel Mount (see fig. 3a)
fig. 1a
Wheel hubs are mounted to the D shaped shaft of each motor. Hubs have a tapped hole
on the side for a socket head screw.
Apply liquid thread lock to the screw and install into hub. Slide the hub onto the motor
shaft and tighten down the screw onto the flat part of the motor shaft.
Screw the set screws into the flat side of the motor shaft until snug.
fig. 2a
The inside portion of the wheel rim has a hex shaped pocket that slides onto the hub.
Slide each wheel onto a hub and install the wheel retainer screw with liquid thread lock.
fig. 3a
WARNING
Unpacking
Mechanical Assembly
Motor Mount (see fig. 1a)
